mode and action status

17:47 Apr 19, 2018 

Sulla pagina dell'articolo dice:
You have 8 programmable loops for your pedals, but now you can set up as one series loop of 8 or you can split them into 2 loops of 4. This means that loop one can be for your pre amp effects (OD, distortion etc.) then loop two can be plugged into your amps FX loop and used for post amp effects (delay, reverb etc).
Another great new feature of this looper is the 4 switch triggers. This means that you can control up to 4 switchable functions on external devices right from this looper via 4 1/4 inch jacks (amp channels, effect modes etc.). You can even program each trigger to latch or make a momentary contact and you can also set the polarity (Normally open/Normally closed). Some amps may need a custom cable to work with this looper.


I 4 interruttori si riferiscono alla coppia send/return (che sono l'uscita e l'ingresso del cavo). Con l'interruttore action status quindi deve indicare lo stato, attivo/disattivo. Lo controlli accendendolo/spegnendolo.
Infatti, si vede status all'inizio dell'apparecchio con i led che indicano lo stato (acceso/spento).

14:48 Apr 19, 2018 

https://www.accordo.it/article/viewPub/3